CT-120A Controller for Electric Scooter

 

Operation Instructions

--Performance and Features--

1. High efficiency, low heat generation, capable of working normally for 3 minutes when the motor is blocked.
2. Provided with the following protection circuits:
(1) Current limiting: This prevents the motor current from exceeding the specified value thus avoids damage to the motor and the controller due to over-current.
(2)
Battery under-voltage protection: When battery voltage lowers to specified value, the controller automatically cuts off the battery output so over-discharge is avoided, thus longer battery life of cyclic use.
(3) Power cut-off during braking: The brake switch makes when braking is underway. A signal is fed to the controller, which in turn cuts off battery output automatically.
(4) Over-speed prevention during electric charging: During charging of the battery, the controller renders the speed adjusting turn handle temporarily inoperable, preventing over-speed due to mistaken manipulation.
3. Epoxy capsulated, thus water-moisture proof and shock proof.
4. Suspended terminal easy of connection and reliable.

--Technical Parameters --


Note: Interface output voltage for power indicator and brake indicator may be customized.

-- Installation and Wring --

1. Power lines

2. Motor output lines (with DJ7022-6.3-21 connecting plug)

3. Brake signal line and speed adjusting signal line (with DJ7061A-2.8-21 connecting plug)

4. Interface for electric door lock (with DJ7031A-2.8-11 connecting plug)(电门锁接口)

For electric door lock, 5A fuse tube in series connection is used. When short-circuit happens in a load circuit other than the motor circuit, the fuse will be burnt and the controller is thus protected. In this case, just replace with a fuse tube of the same capacity after the trouble of short-circuit is repaired.

5. Interface for electric charger (with DJ7021A-2.8-11 connecting plug)

6. Interface for power indicator (with SM-2P connecting plug)

7. Interface for tail lamp (with DJ7021A-2.8-11 connecting plug)

--Precautions-

1. Ascertain that rated voltage of the controller corresponds to the nominal voltage of the battery.
2. When wiring is made, always match male and female terminals and colour of wire. After connecting a plug to a socket, use heat shrinkage tube or tape to fix.
3. The red positive power line and the black earth wire shall not be inversed between each other, otherwise the controller is damaged!! Recommended wiring procedure: connect the earth and other wires first, and only after such wiring is ascertained as correct may the positive power line be connected.